Westinghouse PSL632W User Manual download pdf (Page 24)

CONNECTING TO SERVICES AND COMMISSIONING

Important: Flat fibre washer

must be installed

Appliance

Gas Flow

NG Regulator

Internal

Flange

– If the low settings on the hotplate burners require adjustment then disconnect the

power and remove the knobs and skirts. Turn the adjustment screw in the valve body

adjacent to the spindle to adjust the flame using a long fine screwdriver. Adjust the

flame at a low setting while all other burners are at maximum. Reconnect the power

after all adjustments have been made.

• Check the operation of all other parts of the appliance: clock/timer, oven light, oven

fan, cooling fan, grill element, oven element and indicator lights: If the appliance’s

operation is faulty or cannot be adjusted to perform correctly, place an appropriate

warning notice on the appliance. If the fault appears to be dangerous the appliance

should be disconnected.

• When satisfied with the installation and that the unit is operating correctly, fit the kick

panel using 2 screws provided, or fit the cabinet kick rail.

Note: where a kick rail is used check that the 15mm recess has been cut from the rail as

shown on (page 20), and that the rail is easily removed for service.

• Turn the unit off and instruct the customer on correct operation. Ask the customer to

operate timer and controls and ensure that the correct procedure is understood.

Advise the customer to condition the cooker at 180

C for 4-8 hours to burn off any

manufacturing residue and that unpleasant odours will be emitted during this period.

• Advise the customer that, in the event of fault, they should contact the manufacturers

local service organisation or the retailer from whom the appliance was purchased.

(For contact with service centres, see page 19).

* if the regulator is placed upstream of the appliance inlet, as is normal for appliances

operating on LPG, then the supply pressure and operating pressure are the same.

Gas type Natural Gas Propane ULP

Supply pressure (kPa) 1.13 Min. 2.75* 2.75*

At inlet to appliance Regulator (if fitted)

Operating pressure (kPa) 1.00 2.75 2.75

At appliance test Point

Injector orifice sizes (mm)

Low heat burner 1.00 0.55 0.55

Medium heat burner 1.35 0.70 0.70

High heat burner 1.60 0.82 0.82

Intense heat wok burner 1.80 1.05 0.95

1 2 ... 19 20 21 22 23 24 25 26 27 28

No comments

Westinghouse PSL632W User Manual Page 24