Westinghouse WBRCNG140W Specifications download pdf (Page 43)

WHL-012 REV. 12.17.14

NOTE: The initial display screen will differ depending on a number of factors, including whether the appliance detects a call for heat or

hot water.

The Control System can operate through user and service modes that have specific LCD outputs and dedicated controls, including:

 Changing the Set-Point Temperature

 Lock Mode

 Error Mode

 Status Display Mode

 Outdoor Temperature Mode

 Installer Mode

D. CHANGING THE DHW SET-POINT

The display shows the icon when the DHW set-point can be changed.

Figure 32 – DHW Set-Point Screens

Press the button when the display panel is powered ON to change the DHW Set-Point. The DHW icon and current set-point will

display and flash. This indicates that the DHW Set-Point can be changed. Factory DHW Set-Point is 125

F (51

C). Initial DHW Set-

Point range is 95 – 120

F (35 – 49

C).

Turn the dial counterclockwise to lower and clockwise to raise the DHW set-point. After changing the temperature, press the

button to save the set-point.

To change the DHW Set-Point above 121

F (49.5

C), press and hold the button for five seconds when the display panel is

powered ON. The current DHW set-point will display. The DHW icon will flash. And the scald warning letter “H” (high temperature) will

display. High temperature DHW Set-Point range is 121 – 140

F (49.5 – 60

C).

Turn the dial counterclockwise to lower and clockwise to raise the DHW set-point. After changing the temperature, press the

button to save the set-point.

Hotter water increases the risk of scald injury. Scalding may occur within 5 seconds at a setting of 140

F (60

C). Water temperature

over 125

F can instantly cause severe burns, or death, from scalds. Children, disabled, and elderly are at the highest risk of being

scalded. See instruction manual before setting temperature at appliance. Feel water before bathing or showering!

E. CHANGING THE TEMPERATURE INDICATOR

To change the temperature indicator from Fahrenheit to Celsius, press and hold the button for more than five seconds when the

display panel is powered ON. This will toggle the temperature unit indicated on the display.

F. CHANGING THE CH SET-POINT

Press the button when the display panel is powered ON. The display will appear as follows. The set-point will flash when the CH

Set-Point can be changed.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 75 76

Comments to this Manuals

No comments

Westinghouse WBRCNG140W Specifications Page 43

Comments to this Manuals

Related products and manuals for Water heaters & boilers Westinghouse WBRCNG140W