Westinghouse WBRCNG140F Installation Manual download pdf (Page 43)

WHL-015 REV. 12.17.14

Press the button again to return to Operation Mode.

NOTE: The Control System will not allow the changes if Lock Mode is activated. Lock Mode will have to be turned off before making

further changes.

Parameter

Detail

Description

O: ot

Outdoor temperature

Current outdoor sensor temperature

A: Li or A: GA

DHW Water flow rate

Current flow (Li: LPM, GA: GPM)

b: It

CH return water temperature

Current CH return water temperature

C: Fr

FAN speed (RPM)

Current fan speed (RPM)

d: Lc

Lock function (Lock)

Lock Mode “ON”/”OFF”

E: oP

CH supply temperature (Operating temperature)

Current CH supply temperature

F: dH

DHW outlet temperature

Current DHW outlet temperature

H: Eh

Exhaust temperature

Current exhaust temperature

I: St

Internal storage tank temperature

Current stored water temperature

Parameter

Detail

Description

J: oH

CH water overheat temperature

Current temperature on the overheating sensor.

L: rt

1: PH

Burner Operation

Time

Supply power time

L:rt display on sub menu

Unit : 100 hour

2: rh

Burner operation time

Unit : 1 hour

3: rH

Burner operation time

Unit : 1,000 hour

4: It

Ignition cycles

Cycle : 10 times

5: IH

Ignition cycles

Cycle : 10,000 times

P: Ou

Displays output condition for Internal recirculation

pump, and heating pump.

Items

1st

2nd

3rd

Internal DHW

Storage pump

Internal CH

Primary

Pump

Not

Used

Stop

Operation

Table 20 – Status Mode Display Screen Descriptions

I. INSTALLER MODE

Installer Mode will activate when the button is pressed and held for five seconds while the display is powered OFF. If the display is

powered on, press the button to turn it off before pressing and holding the button for five seconds.

Figure 34 – Installer Mode Screens

Toggle through items that can be viewed/changed by turning the dial . To view/change an item, press the button. Some

displayed items can be changed by turning the dial counterclockwise to lower and clockwise to raise the displayed value. Press the

button again to save settings.

To leave Installer Mode, press the button again. The display will return to power off mode.

Display

Default

Detail

Description

1: EH

E0:00

Error history up to 10

Check last 10 error codes (E0 - E9)

2: cE

OFF

Delete Error history

Select “ON” to delete error code history

Range: ON or OFF

3: In

OFF

Initialized system

Select “ON” to reset to factory setting

(Burner operation time, Ignition cycles, and Supply power time will not be

reset)

Range: ON or OFF

4: Fu

Change unit for water

volume

Range: GA or Li

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 72 73

Comments to this Manuals

No comments

Westinghouse WBRCNG140F Installation Manual Page 43

Comments to this Manuals

Related products and manuals for Water heaters & boilers Westinghouse WBRCNG140F