Westinghouse WBRCNG140F Installation Manual download pdf (Page 14)

WHL-015 REV. 12.17.14

Cold weather handling – If appliance has been stored in a very cold location (below 0

F) before installation, handle with care until the

plastic components come to room temperature.

Remove all sides of the shipping crate to allow the appliance to be lifted into its installation location. If surface flooring is rough, take

care when sliding appliance into position, as you could damage the appliance.

Carefully consider installation when determining appliance location. Please read the entire manual before attempting installation.

Failure to properly take factors such as appliance venting, piping, condensate removal, and wiring into account before installation could

result in wasted time, money, and possible property damage and personal injury.

B. BEFORE LOCATING THE APPLIANCE

Incorrect ambient conditions can lead to damage to the heating system and put safe operation at risk. Ensure that the appliance

installation location adheres to the information included in this manual. Failure to do so could result in property damage, serious

personal injury, or death.

Failure of appliance or components due to incorrect operating conditions IS NOT covered by product warranty.

1. Installation Area (Mechanical Room) Operating Conditions

 Ensure ambient temperatures are higher than 32

F/0

C and lower than 104

F/40

 Prevent the air from becoming contaminated by the products, places, and conditions listed in this manual.

 Avoid continuously high levels of humidity

 Never close existing ventilation openings

The service life of the appliance’s exposed metallic surfaces, such as the casing, as well as internal surfaces, such as the heat

exchanger, are directly influenced by proximity to damp and salty marine environments. In such areas, higher concentration levels of

chlorides from sea spray coupled with relative humidity can lead to degradation of the heat exchanger and other appliance components.

In these environments, appliances must not be installed using direct vent systems which draw outdoor air for combustion. Such

appliances must be installed using room air for combustion. Indoor air will have a much lower relative humidity and, hence, potential

corrosion will be minimized.

This appliance is certified for indoor installations only. Do not install the appliance outdoors. Failure to install this appliance indoors

could result in substantial property damage, severe personal injury, or death.

2. Check for nearby connections to:

 System water piping

 Venting connections

 Gas supply piping

 Electrical power

 Condensate drain

Locate the appliance where any leakage from the relief valve, related piping, tank, or connections will not result in damage to

surrounding areas or lower floors of the building. The appliance should be located near a floor drain, or installed in an adequately

drained drain pan. Westinghouse WILL NOT be held liable for leakage damages.

To conserve water and energy, insulate all water piping, especially the hot and recirculation water lines.

3. Check area around appliance. Remove any combustible materials, gasoline, and other flammable liquids.

Failure to keep appliance area clear and free of combustible materials, liquids, and vapors can result in substantial property damage,

severe personal injury, or death.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 72 73

Comments to this Manuals

No comments

Westinghouse WBRCNG140F Installation Manual Page 14

Comments to this Manuals

Related products and manuals for Water heaters & boilers Westinghouse WBRCNG140F