Westinghouse WBRCNG140F Installation Manual download pdf (Page 68)

WHL-015 REV. 12.17.14

START-UP REPORT

LIGHT OFF ACTIVITIES

DATE COMPLETED ________________

Yes

1) Fill the

heating system

Check all piping and gas connections, verify all are tight

Has the system been cleaned and flushed?

Has the boiler and the system been purged of all air? Refer

to Start-Up Preparation, this manual.

Has the auto air purge feature been used / set? Refer to

Start-Up Preparation, this manual.

Pressurize system (12 – 15 psi) CH

____ PSI

Pressurize system domestic HW

Add water to prime condensate cup

Percentage of glycol in system (0 – 50%)

____ %

Verify proper near boiler piping (Primary/Secondary)

2) Electrical

Have the power and control wiring been connected per the

wiring diagram in this manual?

Is the supply voltage 120v and polarity correct?

3) Check gas

pipe

Leak test using locally approved methods (consult

jurisdictional code book)

Has the gas supply line been verified to deliver the required

BTU of the appliance?

Has a union and shut-off valve (no less than ½”) been

installed?

Does the gas type match the type indicated on the rating

plate?

Check incoming gas pressure (3.5” to 14” W.C.)

____ in w.c.

Static

If necessary, convert the boiler to the proper gas type

Locate the stickers in the appropriate locations on the boiler

If applicable, have all dip switches been set and verified to

match system requirements?

Verify combustion settings after gas conversion, Carbon

Dioxide

____% CO2

High Fire

____% CO2

Low Fire

Verify combustion settings after gas conversion, Carbon

Monoxide

____ppm

High Fire

____ppm CO

Low Fire

What is the “drop” on light off (No more than 1” W.C.)?

____ in w.c.

Dynamic

4) Venting

Has the appliance been vented with 3” PVC, CPVC,

Polypropylene, or (AL294C) Stainless for Cat IV

appliances?

Ensure no ABS or PVC Cellular core has been used

Is the vent sloped upward toward the terminal at a rate of ¼”

per ft. or 2% grade?

Have all intake and exhaust joints been properly sealed and

tested?

Are all vent runs properly supported?

Have the termination screens been installed?

Is the vent termination a min of 12” above grade or the

highest anticipated snow level?

Is the total developed vent length including elbows within

the stated max vent length restriction?

5) Condensate

piping / tubing

Is the condensate line piped with the approved materials

listed in this manual?

Does the condensate line have an air inlet at the top/

beginning of the drain? Refer to Install the Condensate

Drain, this manual.

Has the condensate been piped over to a drain, and

checked to be free flowing?

If necessary, has a condensate pump and /or a neutralizer

been installed?

FINAL

SIGNED BY TECHNICIAN

DATE

1 2 ... 63 64 65 66 67 68 69 70 71 72 73

Comments to this Manuals

No comments

Westinghouse WBRCNG140F Installation Manual Page 68

Comments to this Manuals

Related products and manuals for Water heaters & boilers Westinghouse WBRCNG140F